DELUXE TRIM PHONE
MODEL PH-301
OPERATING INSTRUCTIONS
HIGH FIDELITY RECEIVER
TELEPHONE
NUMBER PLATE
LIGHTED DIAL KEYPAD
RESET BUTTON
RECEIVER VOLUME
CONTROL
PULSE/TONE
SWITCH
REDIAL/PAUSE BUTTON
MUTE BUTTON
HOOK SWITCH
MICROPHONE
HANDSET
JACK
HANDSET CLIP
(FOR WALL USE)
RINGER HI/LOW/
OFF SWITCH
(AT THE BACK OF
THE PHONE)
WALL JACK
(AT THE BACK OF
THE PHONE)
IMPORTANT
NUMBER INDEX
BASE JACK
PULSE/TONE DIALING
•
•
•
•
•
•
DESK OR WALL MOUNTABLE
RINGER HI/LOW/OFF SWITCH
FULLY MODULAR CORDS INCLUDED
HEARING AID COMPATIBLE
RECEIVER VOLUME CONTROL
NOTE: READ AND FOLLOW THESE INSTRUCTIONS BEFORE USING YOUR TELEPHONE
IB-PH301(MS)-WM-E-113003
IMPORTANT TELEPHONE CO. & FCC INFORMATION
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
CAUTION:
INJURY TO PERSONS, DO NOT OPEN CABINET.
WE SUGGEST THAT YOU REVIEW THE FOLLOWING
INFORMATION PROVIDED BY THE FCC (FEDERAL
COMMUNICATIONS COMMISSION).
FCC REGISTRATION
This telephone set is registered with the FCC based upon compliance with
Part 68 of its rules. Connection of this telephone to the nationwide telecommu-
nications network must be through a standard network jack (RJ11W OR RJ11C)
which you can order from your telephone company if not already installed.
NOTE: FCC registration does not constitute an expressed or implied
guarantee of performance. Only the Lenoxx warranty in this booklet
covers the performance of this telephone set.
IMPORTANT FCC INFORMATION
In the event that terminal equipment causes harm to the telephone network, the
telephone company should notify the customer, if possible, that service may
be stopped. However, where prior notice is impractical, the company may
temporarily cease service providing that they:
1. Promptly notify the customer.
2. Give the customer an opportunity to correct the problem with their
equipment.
3. Inform the customer of the right to bring a complaint to the Federal
Communications Commission pursuant to procedures set out in FCC Rules
and Regulations Subpart E of Part 68 The telephone company may make
changes in its communications facilities, equipments, operations or
procedures, where such action is reasonably required in the operation of its
business and is not inconsistent with the rules and regulations in FCC Part
68. If such changes can be reasonably expected to render any customer
terminal equipment incompatible, the customer shall be given adequate
notice in writing, to allow the customer an opportunity to maintain
uninterrupted service.
RINGER EQUIVALENCE NUMBER (REN):
The REN is useful to determine the quantity of devices you may connect to
your telephone line and still have all of those devices ring when your telephone
number is called. In most areas, but not all, the sum of the REN’s of all
devices connected to one line should not exceed five (5.0). To be certain of the
number of devices you may connect to your line, as determined by the REN,
you should contact your local telephone company to determine the maximum
REN for your calling area.
NOTE:
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television
reception, try the following:
1. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
2. Consult the dealer or an experienced radio/TV technician for help.
GENERAL
The FCC prohibits customer-provided terminal equipment to be connected to
party lines or to be used in conjunction with coin telephone service.
This phone is hearing aid compatible.
2
IB-PH301(MS)-WM-E-113003
INTRODUCTION
Congratulations for purchasing a Durabrand telephone. Your model
PH-301 will provide you with many years of trouble-free
enjoyment.
Your Sales Receipt
You will need your sales receipt should you ever need warranty
service. You should also save the packing materials if you want to
move or ship this set.
CAUTION:
To avoid the possibility of electrical shock, do not use your phone
while in the bathtub or shower or when you are wet. If you
accidentally drop the phone into water, first unplug its cord from the
modular jack, then remove the equipment from the water.
Avoid using this telephone during electrical storms in your
immediate area.
INSTALLATION INSTRUCTIONS
Insert one end of the modular plugs of the COILED HANDSET
CORD into the HANDSET JACK and the other into the BASE JACK
on the BOTTOM of the TELEPHONE BASE (either end can be
plugged in).
TELEPHONE
BASE
HANDSET
JACK
BASE JACK
COILED HANDSET CORD
For Desk Use
Insert the modular plug of the STRAIGHT TELEPHONE LINE
CORD into the modular jack at the BACK of the TELEPHONE
BASE (either end can be plugged in).
The modular plug at the other end of the STRAIGHT TELEPHONE
LINE CORD is for connection to the telephone line jack (either end
can be plugged in.)
STRAIGHT TELEPHONE
LINE CORD
TELEPHONE LINE JACK
For Wall Mounting
WALL MOUNTING WHEN YOU HAVE AMODULAR WALL PLATE
SHORT 4" CORD
1. Use the short 4" cord.
2. Insert either plug into the modular jack
in the TELEPHONE BASE (at the back
of the phone).
3. Insert the other end into the wall
jack.
4. Hang the TELEPHONE BASE on the
wall plate studs and push down to lock.
IB-PH301(MS)-WM-E-113003
3
TELEPHONE OPERATION
Setting the Pulse/Tone Switch
Set the switch at TONE position for tone type, or set the switch at
PULSE position for pulse (rotary) type (clicking sounds).
If you are not sure which setting you need, try dialing a call with the
switch set to TONE. If the call cannot connect, switch to PULSE.
Ringer HI/LOW/OFF Switch
OFF - The ringer does not sound, for undisturbed privacy.
LOW - Lower rings on incoming calls.
HI - Loud rings on incoming calls.
NOTE: If the RINGER switch is in the OFF position, only THIS
phone will not ring, the other phones in your home will
continue to ring.
NOTE: Even when your phone is set to pulse service, this phone
can be switched to temporary tone dialing for access to
services that require tone signaling like computer systems.
Just press the
button after dialing in pulse and your
buttons can now be used for tone signaling for this call only.
Receiving Calls
1. Pick up the handset when the phone rings.
2. Hang up the handset to release the telephone line when
conversation is completed.
Making Calls
1. Select the desired dialing mode with the PULSE/TONE switch.
2. Pick up the handset and listen for a dial tone.
3. Dial your call.
Last Number Redial
1. To redial last number, just press RESET to get a new dial tone
then press the REDIAL/PAUSE button.
2. This phone will keep the last number dialed in memory even
overnight.
Pause Function
If you make a dial with a pause in the number, simply press the
REDIAL/PAUSE button for the pause.
Handset Volume Control
You can adjust the sound level of the handset receiver by adjusting
the VOLUME control setting.
Mute Button
Allows you to hear the other party without them hearing you. To use
the mute function, press and hold down the MUTE button.
Release the button to return to normal.
WALL MOUNTING WITHOUT A WALL PLATE
FOLLOW THESE INSTRUCTIONS TO
Drill one hole
MOUNT THE PHONE ON THE WALL
WITHOUT
PLATE.
A
STANDARD WALL
1. Drill 2 holes 315
apart.
/16" (100mm)
2. Put a screw into each hole and
Make sure space
between holes is
3
100 mm
leave
/16" (5mm) of the head
exposed.
3. Connect the straight cord to the
phone and wall jack.
4. Put the key hole slots over the
screws and slide down to secure
phone.
Drill one hole
4
IB-PH301(MS)-WM-E-113003
TROUBLE SHOOTING
LIKELY CAUSES
PROBLEM
1. Plugs disconnected from jacks.
2. Jack improperly wired.
No dial tone
1. Damaged cord.
Phone is dead
2. Jack improperly wired.
3. Line out of order.
Can make calls but 1. RINGER switch is in OFF position.
phone does not ring 2. Ensure plugs are well connected.
1. If your line is conditioned to accept
pulse dialing only, slide PULSE/TONE
Can receive but
cannot make calls
switch to PULSE position.
2. Contact your telephone company to
have your line changed to TONE or
PULSE service.
Static noise on line or
cannot hear the
calling party or
calling party cannot
hear you
Replace the COILED HANDSET CORD.
Any phone store has these cords in
different lengths.
1. If problems with your telephone service occur later, try to
determine if the trouble is with the telephone or with the telephone
company equipment.
Unplug the telephone and try it in a different room or in a
neighbor’s home to see if the phone line or jack is bad.
2. If disconnection of your equipment ends the problem, your
telephone may be the source of the trouble and it should be
tested and repaired if necessary before it is reconnected.
We recommend a cloth or other protective material be placed
under the set when placing it on surface with a natural or lacquer
finish.
LIMITED WARRANTY
We warrant this product to be free from defects in material and
workmanship under normal use for a period of 1 year after purchase and we
will repair it free of charge or replace it at no charge, should it become
defective under this warranty, providing you submit proof of purchase (sales
slip) with the set.
During the initial 1 year period after original purchase, we will service
or exchange, at no charge, the set that is returned to LENOXX
ELECTRONICS CORP. After the initial 1 year from original purchase, we
will repair the unit covering any part(s) that need to be replaced at no charge,
but will charge for the cost of labor, return postage paid by LENOXX.
This warranty does not apply to any products which have been subject
to misuse, neglect or accident. This warranty does not cover broken cabinet.
UNDER NO CIRCUMSTANCES WILL LENOXX ELECTRONICS CORP.
BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not
apply to you.
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state. The following charges apply to
repairs beyond the warranty period: $2.00. Be sure to pack carefully and
return postage paid insured together with your money order (personal checks
will not be accepted) and sales receipt to :
LENOXX ELECTRONICS CORP., 2 GERMAK DRIVE, CARTERET N.J. 07008
For customer service, dial 1-800-315-5885.
( MONDAY - THURSDAY 9:00 AM - 5:00 PM, FRIDAY 9:00 AM - 1:00 PM EST)
© 2004 LENOXX ELECTRONICS CORP.
2 GERMAK DRIVE
CARTERET, N.J. 07008
MADE & PRINTED IN CHINA
IB-PH301(MS)-WM-E-113003
5
|